Uniden BCT15 사용자 설명서
33
Setting Up Your Scanner
To secure the radio, by means of the mounting bracket, to a surface, follow the
steps below:
steps below:
1. Attach the four protective rubber feet to the mounting bracket when you use
the scanner on a flat surface. Do not use them when you mount the bracket
using screws.
using screws.
2. Use the bracket as a template to mark positions for the two mounting screws.
3. At the marked positions, drill holes slightly smaller than the screws.
4. Align the bracket with the threaded holes on the sides of the radio case so the
bracket is beneath the radio. Secure the bracket using the two threaded
knobs. Never overtighten the knobs.
knobs. Never overtighten the knobs.
Once the radio is positioned, connect it to a source of AC power using the supplied
13.8V, 750 mA AC adapter. Insert the barrel of the AC adapter to the jack on the
rear, upper right side of the radio marked
13.8V, 750 mA AC adapter. Insert the barrel of the AC adapter to the jack on the
rear, upper right side of the radio marked
.
Insert the connector of the supplied indoor telescoping antenna to the BNC
Antenna Connector and apply moderate pressure to secure it.
Antenna Connector and apply moderate pressure to secure it.
BCT15
Mounting
Wood
Screws
Screws
Stick-on
Mounting
Feet
Feet
Desk
WARNING!
Use only the Uniden-supplied AC adapter with this scanner.