Uniden BCT15 사용자 설명서
36
1. Remove the bracket if it is attached.
2. Remove the four Philips screws from four small tabs of the case, on the rear,
that secure the outer metal case and pull off the case (toward the rear) with
care.
care.
3. Install the DIN sleeve into the opening in your dashboard, lip facing out.
4. Push out the top and bottom tabs to hold the sleeve firmly in place.
5. Before inserting the scanner in the sleeve, attach the cable from the previously
mounted antenna. Attach the DC Power leads. RED goes to a positive (+)
connection on your fuse block while BLACK connects to the vehicle’s chassis
ground (-).
connection on your fuse block while BLACK connects to the vehicle’s chassis
ground (-).
6. Connect the ORANGE lead to one side of the headlamp switch so that when
you activate the headlights, the scanner’s LCD display changes intensity. Be
sure all the connections are routed away from any potentially pinching or
slicing sheet metal.
sure all the connections are routed away from any potentially pinching or
slicing sheet metal.
7. Slowly slide the scanner into the sleeve until it locks in place.
8. To remove the unit, fully insert the removal keys into each slot on the left and
right edges of the front panel. Carefully slide the radio from the sleeve.
Note: if you plan to connect a GPS unit or external speaker at a later time, expect
to remove the unit for ease of making those connections.
to remove the unit for ease of making those connections.