Uniden BCT15 사용자 설명서
66
front-panel control, the scanner uses the control’s setting (i.e. the scanner pays
attention to the last method used).
attention to the last method used).
Wired Cloning
Using the scanner in a cloning setup lets you transfer programmed data directly
from a source or master BCT15 to a target or slave BCT15. Wired cloning
between other models to the BCT15 is not possible.
from a source or master BCT15 to a target or slave BCT15. Wired cloning
between other models to the BCT15 is not possible.
[MENU]
Wired Clone
F
Master or Slave (select one as the master and one as the slave)
To clone (transfer) data directly from one BCT15 scanner to another BCT15
scanner, you must first connect the scanners to each other using the included
connection cable. Then you must set one scanner as the source and the other as
the target.
scanner, you must first connect the scanners to each other using the included
connection cable. Then you must set one scanner as the source and the other as
the target.
1. Plug the smaller end of the included connection cable into the Front Port. Then
connect the DB9 end of the cable into the Rear Port. Be sure to set the
scanner using the Front Port to Front and the other unit to Rear when
scanner using the Front Port to Front and the other unit to Rear when
making the speed selection.
2. Set the scanner containing the programming you want to transfer as the
master scanner, then set the other scanner as the slave scanner.
3a. (Master scanner) Clone Master Press SCAN Key [SCAN/SEARCH]
Clone Master Connecting
3b. (Slave scanner) Clone Slave Press SCAN Key [SCAN/SEARCH]
Clone Slave Connecting