Konica Minolta 7013 psc 사용자 설명서
TCP/IP Configuration-22
10. Remove, or comment out, your changes to the /etc/ethers file.
11. Stop the rarp daemon and, if you want it to run, restart it.
7.5.1.3 Using
ping
Use the following procedure to enter the IP Address:
1. Turn off the printer.
2. Log in as superuser on a host on the same subnet as the print server. However, if
the server resides on another subnet, complete this procedure to store the IP
address in the print server. Reconnect the print server anywhere on the network,
and then use Telnet or the HTML pages accessed by MAP or a Web Browser util-
ity to change the IP address. See 7.6 Running Telnet, for instructions on using
Telnet.
3. Find the Ethernet address of the Print Server Card. The address is printed on the
configuration status report each time you turn the printer on.
4. Edit the hosts file (usually /etc/hosts) or use NIS or DIS to add the IP address and
print server's node name. See the network administrator for the IP address. For
example, a print server with a name of printfast and an IP address of
192.9.200.200 has the following entry:
192.9.200.200 printfast
5. Add an entry to the arp cache for the Print Server's IP address and Ethernet
address. For example:
arp -s 192.9.200.200 0:40:c8:0:0:ff
6. Check the printer to see that the Print Server is connected to the network. Turn on
the printer.
7. Send a ping command to the Print Server Card to verify it is running on the net-
work. For example:
ping 192.9.200.200 or
ping printfast
The Print Server Card will not respond to this ping command but it will read its IP
address from the packets.
address from the packets.
8. Turn the printer off and back on again and then send the ping command again to
verify that the print server obtained its IP address. If the Print Server has the
address, the result is a confirmation message:
192.9.200.200 is alive