Daewoo 1213 사용자 설명서

20

• Clean the filter when water leaks from the water inlet.

• This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be

caused.

CAUTION : Be careful when draining if the water is hot.

*After a while detergent and fabric softeners leave a deposit in the case;

- It should be cleaned from time to time with a jet of running water.
- If necessary it can be removed completely from the machine by pressing the catch downwards

and by pulling it out.

- To facilitate cleaning, the upper part of the fabric softener compartment can be removed.

*Detergent can also accumulate inside the recess which should be

cleaned occasionally with a brush.

*Once you have finished cleaning, replace the case and run a rinse

cycle without laundry.

1

Pull the power

plug out before
cleaning it.

2

Turn off the water

supply to the
washer and
separate the inlet
hose.

3

Pull the inlet filter

out.

4

Remove the dirt

from the inlet filter
with a brush.

1. Open the lower cover(

1

) by

using a coin. Remove the cap
hose(

2

) to pull out the hose.

2. Unplug the cap hose(

2

), allowing

the water to flow out. At this time
use a vessel to prevent water
flowing on to the floor. When water
does not flow any more, turn the
pump filter(

3

) open to the left.

3. Remove any foreign material

from the pump filter(

3

). After

cleaning, turn the pump filter
clockwise and insert the cap
hose(

2

) to the original place.

Close the lower cover.

1

100

2

3

2

3