Beko tzda523 사용자 설명서

다운로드
페이지 9
IMPORTANT
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller
      than 10 cubic metres.
2. If possible avoid placing the appliance near cookers, radiators or in direct
     sunlight as this will cause the compressor to run for long periods. If installed
     next to a source of heat or refrigerator, maintain the following minimum side
     clearances:
        From Cookers              
  
  2"   (50 mm)
        From Radiators           
12" (300 mm)
        From Refrigerators or Larder Fridge               1"   (25 mm)
3. Make sure that sufficient room is provided around the appliance to ensure free
     air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the
appliance and the ceiling or the underside of a wall cupboard.
4. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn  
to the condenser at the back of the appliance (See diagram).
5. The appliance should be located on a smooth surface.
The two front feet can be adjusted as required.
To ensure that,your appliance is standing
upright adjust the two front feet by turning
clockwise or anti-clockwise, until the product
is in firm contact with the floor. Correct
adjustment of feet avoids excessive
     vibration and noise.
6. Refer to "Cleaning and Care" section to
prepare your appliance for use.
6
5
A special receptacle is supplied to store the
mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the right hand side of the
compressor. (See diagram) Gently remove
the plug from the receptacle. Never pull
the mains cord, you may damage the
appliance. In the case of transportation,
ensure you locate the plug in the receptacle
provided to avoid transit damage.
7.
INDICATOR LIGHTS
There are three coloured indicator lights located inside the appliance which show
the operating mode of the freezer (Fig. 2).
Amber Indicator (1)
Illuminates when the fast-freeze switch (4) is turned on and stays on until the fast
 freeze operation is deactivated manually.
Fast-freeze operation is for freezing fresh food (see Freezing Fresh Food, section).
Green Indicator (2)
Illuminates when the appliance is connected to the mains and will glow as long
as there is electricity present. The green indicator does not give any indication
of the temperature inside the freezer.
Red Indicator (3)
Illuminates
a. When the appliance is first switched on, and will stay on until the pre-set
temperature has been attained.
b. If the appliance is overloaded with fresh food.
c. If the appliance door is left open accidentally.
Thermostat knob (5)
The thermostat knob is located on the top control panel.
Important:
When you press the fast-freeze switch, there may be a short delay before the
compressor starts to operate. This is normal and not a compressor fault.
4
5
1
2
3
Electronic card
(covered by plastic cover)