National Instruments 3.21E+04 사용자 설명서

다운로드
페이지 181
Chapter 4     Signal Connections
AT-MIO/AI E Series User Manual
4-42
 National Instruments Corporation
Either the 20 MHz or 100 kHz internal timebase generates the 
SISOURCE signal unless you select some external source.  Figure 4-25 
shows the timing requirements for the SISOURCE signal.
Figure 4-25.  SISOURCE Signal Timing
Waveform Generation Timing Connections
The analog group defined for your AT E Series board is controlled by 
WFTRIG, UPDATE*, and UISOURCE. 
WFTRIG Signal
Any PFI pin can externally input the WFTRIG signal, which is 
available as an output on the PFI6/WFTRIG pin.
As an input, the WFTRIG signal is configured in the edge-detection 
mode.  You can select any PFI pin as the source for WFTRIG and 
configure the polarity selection for either rising or falling edge.  The 
selected edge of the WFTRIG signal starts the waveform generation for 
the DACs.  The update interval (UI) counter is started if you select 
internally generated UPDATE*.
As an output, the WFTRIG signal reflects the trigger that initiates 
waveform generation.  This is true even if the waveform generation is 
being externally triggered by another PFI.  The output is an active high 
pulse with a pulse width of 50 to 100 ns.  This output is set to tri-state 
at startup.
t
p
t
w
t
w
t
p
t
w
= 50 ns minimum
= 23 ns minimum