Dodge 2009 caliber 사용자 설명서
Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLink
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLink
威 to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink
opener or a gate operator, replace “Programming
HomeLink
威” Step 3 with the following:
3. Continue to press and hold the HomeLink
威 button
while you press and release - every two seconds
(“cycle”) your hand-held transmitter until HomeLink
(“cycle”) your hand-held transmitter until HomeLink
威
has successfully accepted the frequency signal. The
indicator light will flash slowly and then rapidly when
fully trained.
indicator light will flash slowly and then rapidly when
fully trained.
If you unplugged the device for training, plug it back in
at this time.
at this time.
Then proceed with Step 4 under “Programming
HomeLink
HomeLink
威” earlier in this section.
Using HomeLink
姞
To operate, simply press and release the programmed
HomeLink
HomeLink
威 button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
Security system, entry door lock, home/office lighting,
etc. The hand-held transmitter of the device may also be
used at any time.
Security system, entry door lock, home/office lighting,
etc. The hand-held transmitter of the device may also be
used at any time.
142
UNDERSTANDING THE FEATURES OF YOUR VEHICLE