DMP Electronics XR500 사용자 설명서

14

MESSAGING SETUP 

This section allows you to enter the information needed to receive messages 

directly from the panel via email and In Touch™ SMS Text using Network or Cellular 

communication.  All of the name and password options below allow up to 32 

lowercase characters to be entered. The Destination addresses allow up to 48

characters to be entered. System Name is displayed with initial caps.
The transmitted messages are:

 

• Zone Alarms by Zone Name

 

• Zone Troubles by Zone Name

 

• Zone Bypass by User

 

• Arming (Closings) by User

 

• Disarming (Openings) by User

 

• Late to Close

 

• AC Power Trouble and Restoral

 

• System Low Battery

 

• Ambush

 

• Abort, Cancel and Alarm Verified by User

 

• Check-in by user

Select 

YES to allow the panel to send messages to three programmed destinations. 

Default is NO.

SYSTEM NAME

 

Enter a unique name for the panel. The panel name is used as the sender of the 

message. The text entered is displayed with initial caps. If this field is left blank, the

panel account number is sent. 

DESTINATION 1

-

Enter the first email address or cell phone number where messages will be sent. The

message can be sent to any device (computer, cell phone, PDA) as long as a valid

email address or cell phone number is entered. When entering email addresses,

press the 7 digit key followed by the fourth Select Key to add the @ symbol and the

9 digit key followed by the fourth Select Key to add the _ symbol. See the Entering

Non-Alpha Characters section for additional symbols.

 

Note: Mail servers that require Transport Layer Security (TLS) encryption are not

supported by the XR500 Series. 

If Destination 1 is a 10-digit cellular number, enter a user’s user number from this

account.  This option is used when sending commands such as arming or disarming 

back to the panel using In Touch™ SMS Text from the same cell phone or PDA.  The 

user number must have the authority to perform the commands as if it occurred at the 

keypad.  In Touch™ SMS Text command operation is available in XR500 Series panels 

using version 205 or higher. Entering 0 (zero) disables this option. Default is 0.

DESTINATION 2

-

Enter the second destination email address or cell phone number.

If Destination 2 is a cellular number, enter the user’s User Number for  

arming/disarming authorization.

DESTINATION 3 

-

Enter the third destination email address or cell phone number.

ENABLE MESSAGING
                  NO  YES

-

 

DESTINATION 1 

USER NUMBER:        0

 

DESTINATION 2 

USER NUMBER:        0