Dakota Digital lat-nr380 사용자 설명서
5. Pass the wires through the tail light housing where the original bulb and socket were.
Feed the wires through the larger hole in the mounting plate. Guide the mounting plate to the
bottom of the housing. The flat side of the mounting plate should be down and the side with the
slight raised center should go up into the housing. This will align the mount in the original housing.
bottom of the housing. The flat side of the mounting plate should be down and the side with the
slight raised center should go up into the housing. This will align the mount in the original housing.
6. Now hold the LED assembly so that it is centered over the hole where the original bulb was
located and align the mounting plate from the bottom with the slot in the housing. The screw
holes should be lined up.
holes should be lined up.
7. Screw the mounting plate into the assembly mount using the two previously removed 3/8” 6-32
screws.
8. Install the lens and/or re-assemble the tail light housing, insuring all gaskets are intact and in
place. Install the tail light housing back into the vehicle. You are now ready to wire the LED
assembly into the vehicle tail light harness.
assembly into the vehicle tail light harness.
MAN# 650233