Cub Cadet cub cadet snow blower 945 swe 사용자 설명서

1. 

Disconnect the chute crank assembly at the discharge 
chute end by removing the hairpin clip and the flat washer. 
Refer to Figure 7-1.

2. 

Remove the hex screws and lock nuts securing the forward 

end of the support tubes to the back of the auger housing, 

and pivot the tubes upward.

3. 

Remove the plastic belt cover on the front of the engine by 

removing the three self-tapping screws. See Figure 7-2.

4. 

Loosen the bolt shown in Figure 7-3 securing the belt 
keeper bracket and remove the other bolt. Push the belt 
keeper bracket up off the engine pulley. Refer to Figure 7-3.

To remove and replace your snow thrower’s auger belt, proceed 

as follows:
1. 

Remove the hairpin clip and flat washer from the ferrule 

in order to disconnect the auger idler rod from the brake 

bracket assembly. See Figure 7-4.