bk av2600 사용자 설명서

8 

The AV2600 has up to six output channels that may be paralleled (mono). This feature allows the amplifier to 
increase its output power into lower impedance speakers. Set all ‘AMP ON’, ‘L + R’ and ‘BUS’ DIP switches to the 
‘ON’ position for the desired channels. Set the ‘SENSE’ DIP switches to the ‘OFF’ position for these channels. 
Place the volume jumpers for these channels to use the ‘NO VOL’ jumper terminals. 

 

 
The desired speaker output terminals on the AV2600 rear panel must now be paralleled in order to complete the 
setup. Connect the (+) terminals for all desired channels together using jumper wires (not supplied with the 
amplifier). Finally, connect a speaker cable from one of the paralleled amplifier channels to the speaker terminals. 
Input the signal source into the audio BUS input. The illustration below shows an example of two channels 
connected in parallel.