National Instruments DIO 6533 사용자 설명서

© National Instruments Corporation

2-1

DIO 6533 User Manual

This chapter explains how to install and configure your DIO 6533 
device.

Install your software before you install your 6533 device. Refer to the 
appropriate release notes indicated below for specific instructions on 
the software installation sequence.

If you are using NI-DAQ, refer to your NI-DAQ release notes. Find 
the installation section for your operating system and follow the 
instructions given there.

If you are using LabVIEW, LabWindows/CVI, or other National 
Instruments application software packages, refer to the appropriate 
release notes. After you have installed your application software, refer 
to your NI-DAQ release notes and follow the instructions given there 
for your operating system and application software package.

Following are general installation instructions for each device. Consult 
your computer or chassis user manual or technical reference manual for 
specific instructions about installing new devices in your computer or 
chassis.

You can install a PCI-DIO-32HS in any available 5 V PCI expansion 
slot in your computer.

1.

Turn off and unplug your computer.

2.

Remove the top cover or access port to the expansion slots.

3.

Remove the expansion slot cover on the back panel of the 
computer.