briggs--stratton 5900861 사용자 설명서

www.SnapperPro.com

Return-To-Neutral Adjustment

To determine if it is necessary to adjust the neutral return,
perform the following steps.

1. Disengage the PTO, engage the parking brake and turn

off the engine.

2. Move the ground speed control levers into the operating

position, pull levers rearward and release.

3. Move the ground speed control levers out towards the

neutral position. If the levers do not align with the
notches in the neutral lock plate, it is necessary to adjust
the adjustment linkage rod (B, Figure 37).

Adjustment

1. Pull the ground speed control lever rearward and release

to check position. If the ground speed control lever
does not align itself with the notch in the neutral plate,
then move the set collar (A) forward or back on the
adjustment linkage rod (B) until the speed control lever
aligns with the notch. Retighten the set collar.

2. Make sure that the neutral return bushing (D) is seated

correctly in the spring stop plate (E).

3. Pull the ground speed control lever rearward and release

to check position again. Adjust as necessary to align
the ground speed control levers with the notches in the
neutral lock plate.

It is important to note that after every adjustment
of the neutral return rod, the lever must be pulled
rearward and released to properly check the neutral
position.

Regular Maintenance

Figure 37. Neutral Return Spring Adjustment
A. Set Collar
B.  Adjustment Linkage Rod
C.  Neutral Return Spring
D.  Neutral Return Bushing
E.  Spring Stop Plate

WARNING

To avoid serious injury, perform adjustments
only with engine stopped, key removed and
tractor on level ground.

Not

for

Reproduction