briggs--stratton 355z 사용자 설명서

This machine is capable of 
throwing objects and debris.  Keep 
bystanders away.

This machine can amputate limbs.  
Keep bystanders and children away 
when engine is running.

This mower deck can amputate 
limbs.  Keep hands and feet away 
from blades.

Do not operate the engine in an 
unventilated area.

Keep unit free of grass, leaves and 
excess oil.  Do not add fuel while 
engine is hot or running.  Stop 
engine and allow to cool for at least 3 minutes prior to 
adding fuel.  Do not add fuel indoors, in an enclosed 
trailer, garage or other enclosed areas.  Clean up 
spilled fuel.  Do not smoke while operating this 
machine.

This machine can crush and cut.   
Keep hands away from belts and 
pulleys.

The alert symbol 

 is used to identity safety 

information about hazards that can result in personal 
injury.  A signal word (DANGER, WARNING, or 
CAUTION) is used with the alert symbol to indicate 
the likelihood and the potential severity of the injury.  
In addition, a hazard icon may be used to represent 
the type of hazard.  An explanation of hazard levels 
and icons are as follows:

This indicates a hazard which, if not avoided, will 
result in serious injury or death.

This indicates a hazard which, if not avoided, could 
result in serial injury or death.

This indicates a hazard which, if not avoided, might 
result in minor or moderate injury.

These messages presented without the alert symbol 
indicate a situation where the unit or property could be 
damaged.

Safety Icons

Read and understand the 
Operator’s Manual before using 
this machine.

Remove the key and consult 
technical literature before 
performing repairs or maintenance.

Operating on steep slopes can 
cause sliding and loss of steering, 
control and rollover.  Do not use 
this machine on slopes greater than 15°.  This limit 
was determined per CEN Standard EN 836:1997, 
Section 5.2.2 and is based on the EN 836 Stability 
Test procedure described in Section 4.2.4.2. The 15 
degree “limit of stability” is equal to 50% of the angle 
at which machine lift-off occurred in static tests. Actual 
dynamic stability may vary depending on operating 
conditions.

Do not operate on any slopes when 
wet or slippery.  Do not operate 
near drop-offs or near water.

Avoid contact with engine and 
hot surfaces.  Wait for unit to cool 
before touching.

Not 

for  

Reproduction