Zebra 49834 사용자 설명서

Drive System—Stepper Motor

57518L-001 Rev. A

3/18/05

170PAX4 Maintenance Manual

203

Remove the five mounting screws securing the enclosure frame. 

. Remove the four motor cables, J1, J2, J5, and J6 from the DC motor 

control board.

Disconnect the cable secured by the cable clamp, but leave the cable clamp secured to the 
DC motor control board.

Which model print engine do you have?

One of the screws is a hex (Allen) screw, while the other four are Phillips screws.

A right-hand print 
engine

Follow the wires from J3 up to the DC power supply and remove 
the connector from the power supply.

A left-hand print 
engine

One end has already been disconnected from the applicator 
interface board. Follow the cable up to the DC power supply 
and remove the other connector from the power supply.

Remove J3 from the DC motor control board.