Zebra 49834 사용자 설명서
Preventive and Corrective Maintenance
Printed Circuit Boards—Ribbon Tension Control Board
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
261
Replace the Ribbon Tension Control Board
1.
. Install the new ribbon tension control board using the three hex screws
previously removed.
2.
Which model print engine do you have?
3.
Reconnect all cables to the new ribbon tension control board.
4.
Refer to
to close the print engine, reinstall it into the applicator,
and to resume printer operation.
If you have a…
Then…
Right-Hand Model
a.
Secure the ribbon tension control board power cable inside
the cable clamp.
the cable clamp.
b.
Reinstall the last hex screw, cable clamp, and cable in the
lower right corner of the ribbon tension control board.
lower right corner of the ribbon tension control board.
Left-Hand Model
a.
Secure the applicator interface power cable inside the cable
clamp.
clamp.
b.
Reinstall the last hex screw, cable clamp, and cable in the
lower left corner of the ribbon tension control board.
lower left corner of the ribbon tension control board.