Crestron simpl plus language ref 사용자 설명서

Crestron SIMPL+

®

Software 

z 9

 

One or both targets may be selected to compile the program for both types of control 
systems. When compiling a program for a specific type of control system, an error 
message appears if a wrong control system target is selected that does not support a 
particular function or syntax.. Shown below are the two target selection buttons of the 
menu toolbar.

X-GEN - shortcut to Build | X-Generation Control Systems Target 2 - shortcut to 
Build | 2-Series Control Systems Target. (This is the default setting upon opening 
SIMPL+.)

NOTE: In previous versions of SIMPL+, the settings for the target types were 
system-wide. Those settings applied to all SIMPL+ modules that were opened and not 
specific to the active module being edited. In version 3.00, the target type setting is 
specific only to the active module being edited and saved within that module. The 
toolbar buttons reflect the target type of the active module within the SIMPL+ 
environment. 

NOTE: If a program is compiled for the wrong type of control system, an error 
message appears when attempting to upload, and the program must be recompiled.