Namco Bandai Games 90500074 사용자 설명서

Page 75

Solenoid Plunger

Delrin Washer

Install the solenoid spring (S) so the
spring hook comes in contact with
the side of the spacer (6dia x 5)

Flat Washer (M6)

E-clip

Spacer (6dia x 5)

Solenoid Shaft

Spring Hook

Solenoid Spring

Spacer (6dia x 10)

Tension Spring

To remove the solenoid plunger remove one of the E-Clips from the solenoid

shaft#2, the flat washer (M6) and spacer (6dia x 5). Withdraw the solenoid

shaft#2 releasing the solenoid springs, tension spring, spacers (6dia x 10), and

delrin washers.

Note: The solenoid springs are wound in different directions. When refitting the

solenoid springs ensure that the hook of the spring is in contact with the space

(6dia x 5).

After replacing the shutter solenoid, it is recommended that a good quality

Silicone Grease is applied to the solenoid shaft#2 and to the supports for the

solenoid and tension springs.

After replacing the solenoid, ensure that the solenoid position is adjusted

correctly.

(See section 6-5 page 44)