Iomega 333401 사용자 설명서

At the a:\> prompt, type in the name of the utility you need to
run.
FDISK: repartitions your hard disk(s), for example a:\>FDISK.  If
you use FDISK, you need to reboot off of the Recover Disk #1
before using FORMAT or SYS or continuing to the next step.
FORMAT:  formats one or more partitioned drives, for example,
a:\>FORMAT C:
SYS: installs the system boot files onto the hard disk, for example,
a:\>SYS C:

5.

After using the utilities, you must insert the FullBack disk labeled
Recover Disk and reboot.  The FullBack recovery program will
begin.

6.

Follow your on-screen instructions to complete the FullBack
recovery. (A full recovery of 2GB could take over 24 hours
depending on the speed of your computer.)

Iomega’s Ditto Max and Flash!File technology lets you use your tapes for
more than just back up.  Now you can drag and drop files onto a drive
letter for your Ditto Max tape drive just like on your hard drive or floppy
disk.  A special area (125 MB) on the tape is reserved for those files and
your average access time is only five seconds!

There are a few simple reasons why your tape drive may not be detected by
your system. If your parallel port drive is not detected, refer to the “Solving
Problems” section under Using Your Ditto Tape Drive in this guide.

If you installed an internal tape drive with a Ditto Dash DX or Ditto Dash
accelerator card and the system cannot detect the drive, you may be
experiencing conflicts in the DMA, IRQ, and I/O addresses for the card.
Refer to the “Solving Problems” section under Using Your Ditto Tape Drive
in this guide.