Generac 005415-0 사용자 설명서

2. 120/240 VAC loads — one load with a maximum total watt-

age requirement equal to the generator’s rated power output,

and 240V across the generator output terminals; or two sepa-

rate loads, each with a maximum total wattage requirement

equal to half of the generator’s rated power output (in watts),

and 120V across the generator output terminals. Figure 1.2,

shows the generator lead wire connections for 120/240 VAC

loads. Also refer to the "Line Breakers" section for circuit

breaker ratings.

This procedure should be done by an Authorized Service Dealer or

other qualified installer.

Figure 1.2 - Connection for 120/240 Volts

RED

WHITE

BLACK

GROUNDED NEUTRAL

STATOR POWER
WINDINGS

CB1

CB2

1.6 SPECIFICATIONS

1.6.1 FUEL REQUIREMENTS (GASOLINE)

This generator is equipped with a gasoline fuel system as standard

equipment. Specific installations may provide either a separate fuel

tank for the generator, or the generator may “share” the vehicle

engine’s fuel tank.

1.6.1.1 Fuel Consumption (gph)

Model

10% Load

50% Load

100% Load

RV45G

.33

.45

.73

RV55G

.35

.55

.89

RV65G

.37

.65

.97

NOTE

Some installations using a “shared” fuel tank may have a gen-

erator fuel pickup tube that is shorter than the vehicle engine’s

pickup tube. Such an arrangement causes the generator engine

to “run out of gas” while adequate fuel for the vehicle remains

in the tank.
To reduce lead and carbon deposits use high quality UNLEADED

gasoline with the generator. Leaded REGULAR grade gasoline is an

acceptable substitute.

NOTE:

Using unleaded gasoline contributes to longer engine valve life by

reducing lead and carbon deposits.

The manufacturer does not recommend

using any gasoline containing alcohol (such

as “gasohol”). If using any gasoline contain-

ing alcohol, it must not contain more than

10 percent ethanol (Do not use E85), and it

must be removed from the generator during

storage. Do NOT use any gasoline contain-

ing methanol. If using gasoline with alcohol,

inspect more frequently for fuel leaks and

other abnormalities.

1.6.2 ENGINE OIL REQUIREMENTS

All oil should meet minimum American Petroleum Institute (API)

Service Class SJ, SL or better. Use no special additives. Select the

oil's viscosity grade according to the expected operating tempera-

ture (also see chart).

SAE 30

•

Above 32° F

10W-30

•

Between 40° F and -10° F

Synthetic 5W-30

•

10° F and below

S A E 3 0

S y n t h e t i c 5 W - 3 0

1 0 W - 3 0

Crankcase and oil filter capacity is approximately 1.4 L or 1.5 U.S.

quarts. DO NOT use special additives. See sections "Checking the

Engine Oil Level" and "Changing the Engine Oil and/or Oil Filter" for

oil level check and filling procedures.

General Information