lift-master 65 5208 사용자 설명서
DUAL TROLLEY MODIFICATION
(For Use With Models: T and GT )
65-5208 and 65-52081
DESCRIPTION
INSTRUCTION SHEET, DUAL TROLLEY MODIFICATION
DOOR CURVED ARM
DOOR BRACKET
BEARING ASSEMBLY
SPROCKET, 48B14 1” BORE
SLIDER ASSEMBLY
STRAIGHT ARM ASSEMBLY
FRONT IDLER ASSEMBLY, #48 DRIVE CHAIN
FRONT IDLER ASSEMBLY, #41 DRIVE CHAIN
HARDWARE BAG, ST
HARDWARE BAG FOR MANUAL HOIST
ROLL PIN
QUANTITY
1
2
2
2
2
2
2
SEE NOTE 1
SEE NOTE 2
1
1
2
PART NUMBER
01-12198
10-10203
10-10204
12-11438
15-48B14XX
75-10170
75-10214
75-11502
75-11503
77-10200
77-11982
86-RPO8-108
APPLICATION REQUIREMENTS:
This modification is available to model T and GT operators. For 1/2 H.P. and lower drawbar
operators use #48 drive chain. For 3/4 H.P. and higher drawbar operators use #41 drive chain.
operators use #48 drive chain. For 3/4 H.P. and higher drawbar operators use #41 drive chain.
FUNCTIONS:
Provides stabilization of drive system on very wide (over 22 ft.) standard lift sectional doors
utilizing drawbar operators.
utilizing drawbar operators.
Greatly minimizes the risk of damage to the top section of the door which might otherwise
occur on very wide door driven by a single, centered drawbar system.
occur on very wide door driven by a single, centered drawbar system.
PARTS LIST:
Unpack kit to verify the parts listed below are included. Refer to installation on following pages.
Unpack kit to verify the parts listed below are included. Refer to installation on following pages.
NOTES:
1. (2) Shipped With 1/2 and Lower H.P. Operators.
2. (2) Shipped With 3/4 and Higher H.P. Operators