jetway 694tas3a 사용자 설명서

 
 
 
                                                                                                                                                                                                                                                                                                                                                

 
 
 

 

 

 

 

 

This connector supports the provided floppy drive ribbon cable.  After connecting the 
single plug end to motherboard, connect the two plugs at other end to the floppy drives. 

 

 

 

 

(8)  Primary IDE Connector (40-pin block): IDE1 
 

This connector supports the provided IDE hard disk ribbon cable. After connecting the 
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). 
If you install two hard disks, you must configure the second drive to Slave mode by 
setting its jumpers accordingly. Please refer to the documentation of your hard disk for 
the jumper settings. 

 

 

 

 

 

 

(9)  Secondary IDE Connector (40-pin block): IDE2 
 

This connector connects to the next set of Master and Slave hard disks.  Follow the 
same procedure described for the primary IDE connector.  You may also configure two 
hard disks to be both Masters using one ribbon cable on the primary IDE connector and 
another ribbon cable on the secondary IDE connector.