jetway 601tcfr3a 사용자 설명서

 
 
 
                                                                                                                                                                                                                                                                                                                                                

 
 
 

 

 This connector is for on board VGA display connection only.  If you insert any 
external VGA card in PCI slot, you should have the connection to your VGA card’s 
connector. And you have to set “Init Display First” to PCI under Integrated 
Peripherals option in BIOS Setup Utility to get display from PCI VGA card. 

This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin 
D-Subminiature Receptacle Connector for joystick/MIDI Device. 
Line-out :   

Audio output to speaker 

Line-in :    

Audio input to sound chip 

 

Microphone Connector  

For joystick or MIDI Device 

COM1 is the 9-pin D-Subminiature mail connector. The On-board serial port can 
be disabled through BIOS SETUP. Please refer to Chapter 3 “INTEGRATED 
PERIPHERALS SETUP” section for more detail information. 

 

 

 

     

 
 

This connector supports the provided floppy drive ribbon cable.  After connecting 
the single plug end to motherboard, connect the two plugs at other end to the 
floppy drives. 

 

 

 

 

 

This connector supports the provided IDE hard disk ribbon cable. After connecting the 
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). 
If you install two hard disks, you must configure the second drive to Slave mode by