jetway 603tcr4a 사용자 설명서
11
2-3-4 Over clock Running
WARNING! This section is for experienced motherboard installer only. Over
clocking can result in system instability or even shortening life of the
processor.
processor.
After setting the Jumper JMP1 you can choose over clock running by BIOS CMOS
SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose “Miscellaneous
Control” you will see the screen as below then.
You can choose the situation you want to try.
SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose “Miscellaneous
Control” you will see the screen as below then.
You can choose the situation you want to try.
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
Miscellaneous Control
Item Help
CyrixIII Clock Ratio Default
Auto Detect DIMM/PCI Clock Enabled
Spread Spectrum Disabled
** Current Host Clock is 66MHz **
Host Clock at Next Boot is [66MHz/33MHz]
** Current DRAM Clock is 66Mhz **
DRAM Clock at Next Boot is [66]MHz
Auto Detect DIMM/PCI Clock Enabled
Spread Spectrum Disabled
** Current Host Clock is 66MHz **
Host Clock at Next Boot is [66MHz/33MHz]
** Current DRAM Clock is 66Mhz **
DRAM Clock at Next Boot is [66]MHz
Menu Level >
↑↓→←
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
In “Host Clock at Next Boot is” item you can step by step change CPU Host Clock to
approach over clocking.
approach over clocking.
2-4 Install Memory
This motherboard provides
two
168-pin DUAL INLINE MEMORY MODULES
(DIMM) sites for memory expansion available from minimum memory size over
32MB to maximum memory size of 1GB SDRAM.
32MB to maximum memory size of 1GB SDRAM.
Valid Memory Configurations
Total Memory
DIMM1
DIMM2
System Accept or Not
Min.
∼ Max.
DS/SS
Accept
32MB
∼512MB
DS/SS Accept
32MB
∼512MB
DS/SS DS/SS
Accept
32MB
∼1GB
DS : Double Sided DIMM SS : Single Sided DIMM
NOTE! Make sure the total installed memory does not exceeds 1GB, otherwise the
system may hang during startup.