jetway v4mdmpr3a 사용자 설명서

 
 
 
                                                                                                                                                                                                                                                                                                                                                

 
 
 

 

  

 

        

 

 

 

 1   3.3V 

 3.3V 

 

 2   -12V 

 3.3V 

 

 3   GND 

 GND 

 

  4    Soft Power On    5V 

 

 5   GND 

 GND 

 

 6   GND 

 5V 

 

 7   GND 

 GND 

 

 8   -5V 

 Power OK 

 

 9   +5V 

 +5V (for Soft Logic) 

 

10   +5V 

 +12V 

 

The connectors for PS/2 keyboard and PS/2 Mouse. 

(3)  USB Port connector: USB 
    

The connectors are 4-pin connector that connect USB devices to the system board. 

(4)     LAN Port connector: LAN (V4MDM not support) 
        This connector is standard RJ45 connector for Network.  

Parallel Port connector is a 25-pin D-Subminiature Receptacle connector.  The On-board 
Parallel Port can be disabled through the BIOS SETUP.  Please refer to Chapter 3 
“INTEGRATED PERIPHERALS SETUP” section for more detail information. 

This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin 
D-Subminiature Receptacle Connector for joystick/MIDI Device. 
Line-out :   

Audio output to speaker 

Line-in :    

Audio input to sound chip 

 Microphone 

Connector 

For joystick or MIDI Device 

COM1 is the 9-pin D-Subminiature email connector. The On-board serial port can be 
disabled through BIOS SETUP. Please refer to Chapter 3 “INTEGRATED PERIPHERALS 
SETUP” section for more detail information. 

(8)  VGA Connector (15-pin D-Sub) Connector: VGA 
         VGA is the 15-pin D-Subminiature female connector for display monitor. 

  

 

This connector supports the provided floppy drive ribbon cable.  After connecting the 
single plug end to motherboard, connect the two plugs at other end to the floppy drives.