dls ca41 사용자 설명서
Two fullrange speakers to CA22 or CA23
LPF
Off On
80Hz 200Hz
50Hz 500Hz
CA22
CA23
LPF
Off 24 dB
80Hz 200Hz
50Hz 500Hz
12dB
With the HPF-filter in OFF position the amplifier
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 25 – 40 Hz.
allows the speakers to play fullrange. If you for
some reason want to limit the low bass
reproduction switch on the HPF-filter. The typical
setting is then around 25 – 40 Hz.
The LPF-filter should be OFF.
One subwoofer connected in bridge mode to
CA22 or CA23
CA22 or CA23
The HPF filter is here used as subsonic filter to take
away the very deepest frequencies. The typical set-
ting is around 25 – 40 Hz.
away the very deepest frequencies. The typical set-
ting is around 25 – 40 Hz.
CA22
CA23
The LPF will allow low frequencies only and blocks
higher frequencies. A typical setting is 70 – 90 Hz.
In the CA23 amplifier you can select between two
different slopes, 12 dB/ octave or 24 dB/ octave.
Choose the slope and the setting that sounds best
in your car.
higher frequencies. A typical setting is 70 – 90 Hz.
In the CA23 amplifier you can select between two
different slopes, 12 dB/ octave or 24 dB/ octave.
Choose the slope and the setting that sounds best
in your car.
LPF
Off On
80Hz 200Hz
50Hz 500Hz
LPF
Off 24 dB
80Hz 200Hz
50Hz 500Hz
12dB
Filter settings
NOTE!
4 ohm minimum load when using bridge mode
connection. Lower impedances may damage the
amplifier. In bridge mode the amplifier sees a 4
ohm load as 2 ohm.
4 ohm minimum load when using bridge mode
connection. Lower impedances may damage the
amplifier. In bridge mode the amplifier sees a 4
ohm load as 2 ohm.
Filter settings
8
CA22, 23
Speaker wiring CA 22 & CA23
HPF
Off On
50Hz 220Hz
15Hz 500Hz
Subsonic
Off On
40Hz 100Hz
15Hz 150Hz
CA22
CA23
HPF
Off On
50Hz 220Hz
15Hz 500Hz
Subsonic
Off On
40Hz 100Hz
15Hz 150Hz
CA22
CA23