buzz-tools buzzsize 사용자 설명서

 BuzzSize 

Copyright © 2004 Buzz Tools, Inc.

• 

• 

• 

•

•

•

Just as with the resize operation, you can stretch selections up to ten 
percent without any adverse stitching affects. You may be able to stretch 
by a value greater than ten percent if you also change the thickness of the 
thread used to sew the design area. Use a finer thread for areas you have 
reduced and a thicker thread for areas you have enlarged.

Stretch your selection using the 

 located on the Stitches-in-Space 

toolbar. The line that bisects the stretch 

selection indicator is the area of your selection 
that does not move during the stretch operation. 
Change the location of the line by dragging the 
center cross to the desired location (Figure 3-
12). The numeric value of your custom center is 
displayed on the bottom status bar. 

You can toggle between a custom center and the center of the 
selection by clicking on the 

 toolbar button.

Change the angle of stretch for your selection 
by dragging the circular arrow arms that are 
attached to the selection boundary (Figure 3-
13). The percentage rotation is displayed on 
the bottom status bar.

The ability to change the center of your stretch is very handy. For example, 

if you need to stretch an area of your design slightly to eliminate a gap between 
regions of your design, you would position the center of the stretch on the stationary 
edge. As you stretch your selection, you will see it growing away from this center.