cadsoft eagle 4.5 사용자 설명서
CAM Processor: Solder side section of the gerber.cam job.
The diagram shows the ending .whl in the Wheel line for the aperture ta-
The diagram shows the ending .whl in the Wheel line for the aperture ta-
ble. This means that the file democmp.whl is looked for. The output
(File) receives the name democmp.sol. The flag options Optimize and
Pos. coords. are active.
A tolerance of 6 1% is permitted for the aperture selection. This is nec-
A tolerance of 6 1% is permitted for the aperture selection. This is nec-
essary in order to compensate for small rounding errors (of around
0.00005 inch) that can arise during the conversion from mm to inch val-
ues as the aperture table is generated.
The status line below shows which layout is loaded.
The status line below shows which layout is loaded.
9.7 Automating the Output with CAM
Processor Jobs
Defining a Job
A job consists of one or more sections. A section is a group of settings,
as described above in the Set Output Parameters chapter, which defines
the output of one file. In this way you can use a job to generate all the
files that are necessary for a project.
You define a job as follows:
You define a job as follows:
• Start the CAM Processor. No job is loaded at first, unless there is
a file called eagle.cam in the cam directory.
• Click on the Add button and enter a name for the section which is
to be defined.
If, for example, you assign the section name Wheel: Generate Aper-
222
EAGLE Manual