ge-interlogix simon 3 사용자 설명서
Simon Security System
47
Note
To conduct an audio session
using remote phone access
see the Table “Phone Com-
mands for Remote Access”
in the “Testing” section.
To conduct an audio session
using remote phone access
see the Table “Phone Com-
mands for Remote Access”
in the “Testing” section.
Voice Event Notification
Testing this feature requires two people; one at the alarm site and the other at the loca-
tion the panel is programmed to call (Options 5 and/or 43). The panel only reports
alarms and Latchkey when this feature is set up.
tion the panel is programmed to call (Options 5 and/or 43). The panel only reports
alarms and Latchkey when this feature is set up.
1.
Contact the central monitoring station (if system is monitored) to inform them you
are testing the system and not to dispatch authorities.
are testing the system and not to dispatch authorities.
2.
At the system site, put the system into an alarm condition.
3.
At the calling location, pick up the phone after it starts ringing. You should hear the
panel voice announce “Press star for alarm.”
panel voice announce “Press star for alarm.”
4.
Press
‚
and the panel voice identifies the alarm. If there is more than one alarm in
progress, the panel voice identifies all of them.
Important !
You must terminate the call
by pressing
You must terminate the call
by pressing
ƒ
. Otherwise,
the panel may not discon-
nect from the phone line for
up to 2 minutes.
nect from the phone line for
up to 2 minutes.
5.
After all alarms have been identified, the panel announces “Press
ƒ
to exit.”
6.
Press
ƒ
to terminate the call.
RF Thermostat Operation
The following information is important for the RF Thermostat to function through your
control panel:
control panel:
•
The panel needs to be armed to Level 4 (Doors & Windows and Motion Sensors)
for Energy Saving Mode to work.
for Energy Saving Mode to work.
•
If there are no Motion Sensors in the system, the Motion Sensors button must still
be pressed (armed to level 4).
be pressed (armed to level 4).
•
Both options can be turned on at the same time.
•
Thermostat has to be in Auto Mode for Options 81 and 82 to work correctly.
•
If Options 81 and 82 are programmed, the RF Thermostat will change from Energy
Saving Mode to normal operating mode when the panel is armed to level 2.
Saving Mode to normal operating mode when the panel is armed to level 2.
X10 Operation
The following sections describe how to test X10 Lamp, Siren, Appliance, and Universal
Module operation.
Module operation.
Audio Verification Set
Phone Button(s)
Function
0-1
Speak
2
VOX operation
3 or 6
Listen
7
Extend session for 90 more seconds
88
Terminates session with call back (the panel answers on the
first ring if called within 5 minutes)
99
Terminates session with no call back
If the system is monitored by a central station, contact them first before set-
!
ting off any alarms to avoid a false dispatch.
Caution
!