Pentax WG-10 작동 가이드
128
3
Taking Pic
tures
5
Press the four-way controller (3).
The frame moves to [Number of Shots].
6
Set the number of shots.
1
Press the four-way controller (5).
2
Use the four-way controller (23) to set [Number of Shots],
then press the four-way controller (5).
The setting is saved, and the frame returns to [Number of Shots].
7
Press the four-way controller (3).
The frame moves to [Start Delay].
8
Set the start delay.
1
Press the four-way controller (5).
The current time and the recording
start time are displayed in real-time.
2
2
Use the four-way controller (23)
to set the hours, then press
the four-way controller (5).
3
Use the four-way controller (23) to set the minutes, then press
the four-way controller (5).
The setting is saved, and the frame returns to [Start Delay].
9
Press the 3 button twice.
The camera returns to the shooting screen. The operations up to this
point have only configured the [Interval Shoot] settings. To actually use
interval shooting, you must select [Interval Shoot] from the drive mode.
•
Interval Shoot is unavailable in b (Auto Picture), 9 (Green),
F
(Digital Panorama), X (Digital Wide), S (Fireworks)
and O (Voice Recording) modes.
•
Refer to p.145 for instructions on interval shooting for C (Movie)
and
(Underwater Movie).
•
Even if an alarm is set, the alarm will not ring while interval shooting
is being performed.
•
Interval Shoot stops if the SD Memory Card is removed or inserted
during standby.
The Interval Shoot settings can also be configured from the Drive Mode
0
0
MENU
Current Time
Start Time
Start Time
Start Delay
10:00
10:00
10:00
hr.
min.
Interval Shoot
OK
Cancel
OK
WG10_OPM_ENG.book Page 128 Friday, February 1, 2013 5:30 PM