Panasonic nvvp33 작동 가이드

PROG/CHECK

Timer recording

Timer recording

1 / 3

Pos Date Start Stop

VPS

PDC

1   ARD 31/12 10:30 11:30  SP ON
1   ARD 31/12 11:30 12:30  SP ON
2 ZDF 31/12 12:30 13:30  SP ON
4 RTL 31/12 13:30 14:30  SP ON
6 VOX 31/12 14:30 15:30  SP ON
-- - - - - - -/ - -  - -:- - - -:- -  SP - - -

:select

: store

: delete

: exit

ENTER

CANCEL

EXIT

Timer recording

1 / 3

Pos Date Start Stop

VPS

PDC

select

store

delete

exit

ENTER

CANCEL

EXIT

The Timer recording allows you to programme the recording time of TV programmes
up to 1 month in advance. Use the on-screen menu to programme a maximum of 16
recordings.

Quitting the timer mode

Press TIMER. The VCR symbol will turn off.
You can now play back a cassette or make a manual recording. Press TIMER
again to reactivate the previously entered timer programme.

Press PROG/CHECK and select a free storage position

Confirm with ENTER.

Select a station

, and use to set date, week or weekday

Then enter start and stop time

, .

Hold buttons down to change time in 30-minute steps.

Select tape speed: A (Automatic), SP, LP, EP

, .

The VPS/PDC settings may be changed with

(does not apply to VP23).

Press ENTER to save timer programme.

Repeat these steps for further recordings you may wish to programme.

Do not forget to verify that there is enough tape left. The length of the recording
must not exceed the tape left on the video cassette.

Press TIMER to activate the VCR´s timer mode.
Make sure the VCR symbol is displayed. The Timer Rec button on the device
also lights up if the function was not turned off.

The Timer Rec button blinks for 5 seconds if the timer is turned on and you try to
perform a function. Most buttons are blocked when the timer is turned on.