Panasonic DMR-E75V 지침 매뉴얼

[1]

[2]

W, X] to select the channel.

To select with the numeric buttons:
e.g.,

“5”: [0] 

)[5]

“15”: [1] 

)[5]

≥If you keep pressing one of these buttons, the channels 

changes quickly.

[3]

Each time you press the button:
SP

>LP>EP>SP

[4]

¥, VHS REC] to start recording.

∫ To stop recording

Press [

∫, STOP]. 

∫ To pause Recording

Press [

;, PAUSE]. (Press it again to restart recording.)

Note
≥Even if the video cassette you use is labeled “S-VHS”, it is not 

≥When the recording is paused for more than 5 minutes, the unit 

returns to the stop mode.

∫ To Display the Approximate Remaining Tape Time

Select “Tape length” from the on screen display and select the 
corresponding tape length. (

≥The display changes as follows each time [STATUS] is pressed.

Current time

>Operation status and Tape counter

>Remaining tape time>Current time...

≥The remaining tape time may not be displayed correctly depending 

on the tape used.

∫ To specify a time to stop recording

µ

,

Unit’s Display
Each time you press the button:
Counter (cancel) 

# 30 (min.) # 60(min.) # 90 (min.)

^------ 240 (min.) ! 180 (min.) ! 120 (min.) !--}

For your reference
≥This does not work during timer recordings or External Recording.
≥Recording stops and the set time is cleared if you press [∫, STOP].
≥The unit is not turned off automatically when you set the time to 

stop recording by the procedure above and then the recording is 
stopped. 

You can watch play or record discs while recording. The recording 
will not be affected.
≥DVD playback (

≥DVD recording (

This function is not available unless you connect an external 
equipment and this unit with the 21-pin Scart cable.
If an external equipment (for example a satellite receiver) with a 
timer function is connected to the AV2 terminal of this unit by a 
21-pin Scart cable (

l 12), it is possible to control the recording of the 

unit with the equipment.

Preparation
≥Change the “Ext Link” in the SETUP menu to match the connected 

equipment (

≥Timer programming has to be done on the external equipment and 

switch to the timer recording standby mode. Refer to the 
equipment’s operating instructions.

[1]

The unit turns off and switches to the recording standby mode.

≥“EXT L” lights on the unit’s display.

≥Recording begins when a signal is received from the connected 

equipment.

≥As long as a video picture is being transmitted by the external 

equipment, the unit will record it.

[2]

≥If the timer recording is started with keeping the unit turned on, 

the unit is not turned off automatically even after the timer 
recording is completed.

When the following message appears on the television screen, 
≥Press [ENTER] to hide this message. 
≥Press [EXT LINK] to stop recording.

To cancel the external control
Press [EXT LINK] to stop recording or to cancel linked timer 
recording standby.
≥You can also press and hold [∫, STOP] on the VHS main unit for 

more than 3 seconds to stop recording.

≥In order to prevent accidental operation, press [EXT LINK] to 

cancel the setting after recording is finished.

For your reference
≥The video being recorded automatically appears on the television 

when connected to this unit’s AV1 terminal with the 21-pin Scart 
cable.

≥This function does not work with some equipment. Refer to the 

equipment’s operating instructions.

≥The beginnings of recordings may not be recorded correctly in 

some cases.

≥When “Ext Link” is set to “Ext Link 2”, this function does not work if 

the input signal is NTSC system.

Tape speed
SP:

When recording or playing in the Normal mode.

LP:

When playing in the Long play mode.

EP:

When recording or playing in the Extra long play mode.

≥To have a longer recording duration, select “LP” or “EP”.
≥If the image quality is important to you or if you wish to store the 

tape for a long period, select “SP”.

75VGN.book  53 ページ  ２００４年７月２１日　水曜日　午前１１時５４分