Panasonic DMR-E75V 지침 매뉴얼

Before requesting service, check the below items. If you have doubt about the check points, or if the remedies indicated in the chart do not 
solve the problem, consult your dealer.

∫  Common

≥Insert the AC mains lead securely into a known active AC outlet.

–

≥One of the unit’s safety devices may have activated. Press [Í/I] on the main unit to turn the 

unit on.

–

≥Change “FL Display” in the SETUP menu.

≥Set the clock.

≥Times shown may disagree with actual times.
≥More disc space than the actual recording time is used after recording or editing the DVD-R 

200 times or more.

≥While searching, the elapsed time may not display correctly.
≥Even if you erase recorded content from the DVD-R, there is no increase in disc space.

–
–

–
–

≥The tape counter does not change while playing unrecorded parts.

≥The display also appears like this if the tape is dirty or damaged. Consult your dealer if this is 

the case.

–

–

≥Press [DVD] when operating DVD.

≥Press [VHS] when operating VHS.

≥Change manufacturer code. Some televisions cannot be operated even if you change the 

code.

≥The remote control and main unit are using different codes. Change the code on the remote 

control.

Press and hold [ENTER] and the indicated number 
button at the same time for more than 2 seconds.

≥The batteries are depleted. Replace them with new ones.
≥Coloured glass may obstruct the signal reception/transmission.
≥Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight 

exposure.

≥The child lock function is activated.

7
–
–

≥Some operations may be prohibited by the disc.
≥The unit is hot (“U59” appears on the display). Wait until “U59” disappears.
≥One of the unit’s safety devices may have activated.

Reset the unit as follows:
(1) Press [

Í/I] on the main unit to switch to standby.

If the unit doesn’t switch to standby, press and hold [

Í/I] on the main unit for about 

10 seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC mains lead, wait 1 minute, then reconnect it.

(2) Press [

Í/I] to turn the unit on.

≥The child lock function is activated.

–
–
–

≥Press [Í/I] to turn the unit off. Hold down [∫, STOP] and [CH, W] on the DVD main unit 

simultaneously for about 5 seconds.

≥The child lock function is activated.

–

≥Check the connections.
≥You must connect to a television equipped with the Q Link function with a fully wired 21-pin 

Scart cable to download channel presets.

75VGN.book  67 ページ  ２００４年７月２１日　水曜日　午前１１時５４分