Panasonic DMR-ES30V 작동 가이드

VQT0P03

≥Change manufacturer code. Some TVs cannot be operated even if you change the code.
≥Press [AV] to change the input mode to “TV”.

24, 51

≥Press [DVD] when operating DVD.

≥Press [VHS] when operating VHS.

≥The remote control and main unit are using different codes. Change the code on the remote 

control.

Press and hold [ENTER] and the indicated number 
button at the same time for more than 2 seconds.

≥The batteries are depleted. Replace them with new ones.
≥Point the remote control at the remote control sensor on the main unit.
≥Remove obstacles between the remote control and main unit.
≥Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight 

exposure.

≥The child lock function is activated.

12
12

–
–

≥Some operations are prohibited by the disc.
≥The unit is warm (“U59” appears on the unit’s display). Wait until “U59” disappears.
≥One of the unit’s safety devices may have been activated.

Reset the unit as follows:
(1) Press [

Í/I] on the main unit to switch to standby.

If the unit doesn’t switch to standby, press and hold [

Í/I] on the main unit for about 10 

seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC mains lead, wait for about 1 minute, then reconnect it.

(2) Press [

Í/I] on the main unit to turn the unit on.

≥The child lock function is activated.

–

–

≥The unit is recording.
≥The unit may have a problem. While the unit is off, hold down [∫] and [CH, W] on the DVD 

main unit simultaneously for about 5 seconds. Remove the disc and consult the dealer.

≥The child lock function is activated.

–
–

≥Check the connections.

≥Make sure that “Quick Start” is set to “On”.

Even if “Quick Start” is set to “On”, startup is slow if the clock is not set, there was a power 
failure or the AC plug has just been connected.

≥A few dozen seconds after turning on the unit, you can play a disc or start recording to discs 

other than DVD-RAM.

≥Startup takes time for a few minutes after 5:15 a.m. due to system maintenance of this unit.

–

–

≥It may take time to read a disc if it is being used for the first time in this unit or it has not been 

used for a long time.

–

≥This can occur because the signals are being divided between the unit and other equipment. It 

can be solved by using a signal booster, available from audio-visual suppliers.

–

≥Make sure that the TV is connected to the VIDEO OUT terminal, S VIDEO OUT terminal or 

COMPONENT VIDEO OUT terminals on the unit.

≥Make sure that the TV’s input setting (e.g., AV 1) is correct.
≥The TV isn’t compatible with progressive signals. Press and hold [∫] and [“ DVD, DUBBING] 

on the DVD main unit at the same time for about 5 seconds. The setting will change to 
interlace.

14, 15

–
–

≥The colour of the screen may turn to monochrome or the screen may be distorted depending 

on the TV used when you switch the DVD/VHS. However, this is not a malfunction.

–

M7620(GN).book  70 ページ  ２００５年５月２５日　水曜日　午後１２時２分