Panasonic ESRT87 작동 가이드
16
Notes
• The water and detergent will mix after cleaning begins,
making cleaning liquid.
• If “AUTO” mode cannot be selected or the STATUS lamp
glows for 5 seconds when the SELECT button is pressed,
the cleaning liquid needs to be replaced. Replace the
cleaning liquid.
the cleaning liquid needs to be replaced. Replace the
cleaning liquid.
• When replaced, the cleaning liquid will last for approximately
30 days if used once per day. (This will differ depending on
beard thickness and the ambient temperature.)
beard thickness and the ambient temperature.)
• Use the detergent within approximately 6 months after
opening the package. When 6 months have passed,
discard the cleaning liquid, and then pour new water and
detergent into the cleaning liquid unit.
discard the cleaning liquid, and then pour new water and
detergent into the cleaning liquid unit.
• Replace the water and detergent at the same time.
Otherwise the cleaning function may deteriorate.
• Only use self‑cleaning recharger detergent for Panasonic shavers.
►Cleaning the shaver
Remove any soap or water on the shaver if it has been
washed with hand soap or any other detergent.
washed with hand soap or any other detergent.
1
1
Insert the appliance plug
[CN] into the self-cleaning
recharger [B].
[CN] into the self-cleaning
recharger [B].
2
2
Pull up the arm until it clicks.
3
3
Remove the protective cap
[A1] and then attach the
shaver.
[A1] and then attach the
shaver.
4
4
Push down the arm until it
clicks.
clicks.
1
2
4
4
3
5
5
5
Plug in the adaptor [CK] into a household
outlet.
outlet.
• Turn the shaver off before attaching.
• Check that the system outer foil is not deformed or
damaged when you are attaching the shaver.
• Put shaver into the self‑cleaning recharger with the
trimmer handle retracted. If the trimmer handle is not
retracted, it might scratch the cleaning tray.
retracted, it might scratch the cleaning tray.
6
6
Press the SELECT button [BJ] to select the
mode.
mode.
• The “Charge” mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode
changes from “AUTO” “Charge”.
• The modes start approximately 6 seconds after they are
selected.
• The mode will be aborted if the power is cut off. In this
case, perform the mode again from the beginning.
• Do not press the cleaning liquid unit removal button as
the cleaning liquid may spill causing a malfunction.
Mode
Time required (guide)
Charge
Charge
0 to 60 min
AUTO
Clean/Dry
10 min/350 min
Charge
0 to 60 min
• It is not possible to change the mode after
“AUTO” mode has started.