Panasonic DP-MB350 작동 가이드

5

Detailed operating instructions are on the CD-ROM.

L

The area near the recording paper exit may also get 
warm. This is normal.

Never push any objects through slots in this 
unit. This may result in the risk of fire or 
electric shock. Never spill any liquid on the 
unit.

To reduce the risk of electric shock, do not 
disassemble this unit. Take the unit to an 
authorized service center when service is 
required. Opening or removing covers may 
expose you to dangerous voltage or other 
risks. Incorrect reassembly can cause 
electric shock when the unit is subsequently 
used.

Follow all warnings and instructions marked 
on this unit.

Do not spill liquids (detergents, cleansers, 
etc.) onto the telephone line cord plug, or 
allow it to become wet at all. This may cause 
a fire. If the telephone line cord plug 
becomes wet, immediately pull it from the 
telephone wall jack, and do not use.

Unplug this unit from power outlets and refer 
servicing to an authorized service center 
when any of the following conditions occur:

L

If the power cord is damaged or frayed.

L

If liquid has been spilled into the unit.

L

If the unit has been exposed to rain or 
water.

L

If the unit does not work normally by 
following the operating instructions. 
Adjust only controls covered by the 
operating instructions. Improper 
adjustment may require extensive work 
by an authorized service center.

L

If the unit has been dropped or 
physically damaged.

L

If the unit exhibits a distinct change in 
performance.

To assure continued emission limit 
compliance;
–

use only shielded USB cable (Example: 
Hi-Speed USB 2.0 certified cable).

–

use only shielded LAN cable (category 5 
straight cable).

After moving the unit from cold areas to 
warmer areas, wait approximately 30 
minutes before turning on the power switch 
to allow the unit to adjust to the ambient 
temperature. If the power switch is turned on 
too soon after a sudden climate change, 
condensation may form inside the unit, 
causing malfunction.

Never turn the unit upside down or sideways 
when moving it.

Never install telephone wiring during a 
lightning storm.

Never install telephone jacks in wet 
locations unless the jack is specifically 
designed for wet locations.

Never touch uninsulated telephone wires or 
terminals unless the telephone line has 
been disconnected at the network interface.

Use caution when installing or modifying 
telephone lines.

Do not position the unit in a location where it 
is unstable or subject to vibrations.

The printer of this unit utilizes a laser. Use of 
controls or adjustments or performance of 
procedures other than those specified 
herein may result in hazardous radiation 
exposure.

During or immediately after printing, the 
fuser unit gets hot. This is normal. Do not 
touch the fuser unit.

MB350-PNQW1864ZA-QRG-en.book  Page 5  Friday, July 10, 2009  4:26 PM