Panasonic KXHNS103 작동 가이드
Inserting the battery
R USE ONLY a CR2 Lithium battery.
R Confirm the polarities (
R Confirm the polarities (
,
).
1
Remove the main unit cover.
R Lift from the indented area (A)
R Lift from the indented area (A)
and open the main unit cover
(B).
(B).
1
2
2
Insert the battery.
3
Attach the main unit cover.
Registering the
sensor
This procedure is not required for
devices that were included as part of
a bundle.
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
the registration buttons or the [Home
Network] app.
Using registration buttons
1
1
Hub:
Press and hold M
Press and hold M
OTHER
DEVICEN until the LED indicator
blinks slowly in green.
blinks slowly in green.
2
Sensor:
Remove the main unit cover and
press and hold M
Remove the main unit cover and
press and hold M
N until the
the hub sounds one long beep.
Note:
R To cancel without registering the
R To cancel without registering the
sensor, press M
N on the hub and
on the sensor again.
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the sensor by using
the [Home Network] app, you can
assign a name to your devices and
the [Home Network] app, you can
assign a name to your devices and
For assistance, please visit http://shop.panasonic.com/support
9
Setup
HNS103_(en_en)_0119_ver.101.pdf 9
2017/01/25 14:57:41