Panasonic KXTG6481FX 작동 가이드
Programming
26
3
Enter the phone number (24
digits max.). i M
L
digits max.). i M
L
To erase a digit, press {C/T}.
4
{i
c}
Viewing/editing/erasing bar call
numbers
numbers
1
K
(middle soft key)
2
{V}
/{^}: “Caller Barred” i
M
3
{V}
/{^}: Select the desired entry.
L
To exit, press {ic}.
4
Proceed with the desired operation.
■ Editing a number:
■ Editing a number:
K
i {V}/{^}: “Edit” i
M
i Press {<} or {>} to
move the cursor. i Edit the
number. i M i {ic}
number. i M i {ic}
■ Erasing a number:
K
i {V}/{^}: “Erase” i
M
i {V}/{^}: “Yes” i M
i
{ic}
Note:
L
L
When editing, press the desired dial
key to add, {C/T} to erase.
key to add, {C/T} to erase.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Important:
L
Up to 6 handsets can be registered to
the base unit.
Important:
L
The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Registering a handset to the
base unit
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
1
Handset:
K
K
(middle soft key)
2
{V}
/{^}: “Handset Setup” i
M
3
{V}
/{^}: “Register H.set” i
M
4
Base unit:
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L
If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
ringing, press the same button to
stop. Then repeat this step.
L
The next step must be completed
within 90 seconds.
within 90 seconds.
5
Handset:
Wait until “Enter Base PIN” is
displayed. i Enter the base unit
PIN (default: “0000”). i M
L
Wait until “Enter Base PIN” is
displayed. i Enter the base unit
PIN (default: “0000”). i M
L
If you forget your PIN, contact
your nearest Panasonic service
centre.
your nearest Panasonic service
centre.
L
When the handset has been
registered successfully, w stops
flashing.
registered successfully, w stops
flashing.
Note:
L
L
When you purchase an additional
handset, refer to the additional
handset’s installation manual for
registration.
handset, refer to the additional
handset’s installation manual for
registration.
TG6481FX(e).book Page 26 Friday, June 5, 2009 8:50 AM