Kenwood Electronics SLG-7 사용자 설명서
English
23
p
q
r
s
Removing the Rechargeable Battery (Built-in Battery) Before Disposal:
Transmitter
Transmitter
IMPORTANT:
Never attempt to open the Transmitter besides when disposing of it.
For replacement of the built-in battery, contact your nearest Kenwood service agent.
Never attempt to open the Transmitter besides when disposing of it.
For replacement of the built-in battery, contact your nearest Kenwood service agent.
• Remove the built-in battery after having confirmed that it is completely discharged.
• Once the built-in battery is disconnected, do not attempt to reconnect it to the connector
on the circuit board.
• Bring the removed built-in battery to a rechargeable battery recycling business as early as
possible.
1 Remove the four screws from the panel using
the supplied wrench.
2 Remove the three screws from the circuit board
using a precision Phillips screwdriver (+).
3 Take out the circuit board and disconnect
the built-in battery from the connector. Be
careful not to apply an excessive force on the
connector.
careful not to apply an excessive force on the
connector.
4 Take out the built-in battery. Be careful not to
injure your nail or finger during removal.
5 Attach a piece of insulating tape on the
connector at the end of the cable from the
built-in battery, and put it in a plastic bag, etc.
built-in battery, and put it in a plastic bag, etc.
B60-5674-00.indb 23
B60-5674-00.indb 23
07.6.8 5:23:23 PM
07.6.8 5:23:23 PM