Cisco Module 12p Digital Modem f C3600 사양 가이드

다운로드
페이지 3
 
 
Product End-of-Life Notice 
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. 
Page 1 of 3 
End-of-Sale and End-of-Life Announcement for the 
Cisco Digital Modem Network Modules 
EOL5056—Amended 
Cisco Systems
®
 announces the end-of-sale and end-of life dates for the Cisco Digital 
Modem Network Modules. The last day to order the Cisco Digital Modem Network 
Modules is March 16, 2007. Customers with active service contracts will continue to 
receive support from the Cisco Technical Assistance Center (TAC) as shown in Table 1 
of this EoL bulletin. Table 1 describes the end-of-life milestones, definitions, and dates for 
the Cisco Digital Modem Network Modules. Table 2 lists the product part numbers 
affected by this announcement. 
Customers are encouraged to migrate to the Digital Modem PVDM Modules for the Cisco 2800 
and 3800 Series Integrated Services Routers. The Digital Modem PVDM Modules provide the 
Cisco 2800 Series with low-density digital dial access, and provide the Cisco 3800 Series with a 
higher-density digital dial platform. Information about the replacement product can be found at: 
http://www.cisco.com/en/US/products/ps5854/products_data_sheet0900aecd8050918e.html
Table 3 provides relevant information for migrating from the Cisco Digital Modem Network Modules 
to the Digital Modem PVDM Modules. 
Table 1. 
End-of-Life Milestones and Dates for the Cisco Digital Modem Network Modules. 
Milestone 
Definition 
Date 
End-of-Life 
Announcement Date 
The date the document that announces the end of sale and end 
of life of a product is distributed to the general public. 
September 15, 2006 
End-of-Sale Date 
The last date to order the product through Cisco point-of-sale 
mechanisms. The product is no longer for sale after this date. 
March 16, 2007 
Last Ship Date: HW 
The last-possible ship date that can be requested of Cisco 
and/or its contract manufacturers. Actual ship date is dependent 
on lead time. 
June 14, 2007 
End of Routine Failure 
Analysis Date: HW 
The last-possible date a routine failure analysis may be 
performed to determine the cause of product failure or defect. 
March 15, 2008 
End of New Service 
Attachment Date: HW 
For equipment and software that is not covered by a service-and-
support contract, this is the last date to order a new service-and-
support contract or add the equipment and/or software to an 
existing service-and-support contract. 
March 15, 2008 
End of Service 
Contract Renewal 
Date: HW 
The last date to extend or renew a service contract for the 
product.  
June 11, 2011 
Last Date of Support: 
HW 
The last date to receive service and support for the product. After 
this date, all support services for the product are unavailable, 
and the product becomes obsolete. 
March 14, 2012 
HW = Hardware OS, SW = Operating System Software, App. SW = Application Software