Sony XBR-49X900E 사용자 매뉴얼

다운로드
페이지 43
4
US
D:\_SONY TV\SY160244_KHKS UC2 RG\4690447121_US\010COVTOC.fm
masterpage: Left
XBR-75X900E / 75X850E / 65X900E / 65X850E / 55X900E / 49X900E
4-690-447-12(1)
XBR-75/65/55/49X900E
XBR-75/65X850E
• Ensure your TV has adequate ventilation, see page 16.
• For best picture quality, do not expose the screen to direct 
illumination or sunlight. 
• Avoid installing the TV in a room with reflective wall and 
floor materials. 
• Avoid moving the TV from a cold area to a warm area. 
Sudden room temperature changes may cause moisture 
condensation. This may cause the TV to show poor 
picture and/or poor color. Should this occur, allow 
moisture to evaporate completely before powering the TV 
on.
Securing the TV
Sony strongly recommends taking 
measures to prevent the TV from 
toppling over.
Unsecured TVs may topple and result 
in property damage, serious bodily 
injury or even death.
Preventing the TV from Toppling
• Secure the TV to a wall and/or Stand.
• Do not allow children to play or climb on furniture and TV 
sets.
• Avoid placing or hanging items on the TV.
• Never install the TV on:
 slippery, unstable and/or uneven surfaces.
 furniture that can easily be used as steps, such as a 
chest of drawers.
• Install the TV where it cannot be pulled, pushed, or 
knocked over.
• Install the TV so that the TV's Table-Top Stand does not 
protrude out from the Stand (not supplied). If the Table-
Top Stand protrudes out from the Stand, it may cause TV 
set to topple over, fall down, and cause personal injury or 
damage to the TV.
XBR-75/65/55/49X900E
XBR-75/65X850E
• Route all AC power cords and connecting cables so that 
they are not accessible to curious children.
Recommended Measures to Secure the 
TV
Consider the following measures when securing your TV to 
a Stand (not supplied).
1
Secure the Stand for the TV.
Make sure the Stand can adequately support the weight 
of the TV. Use two angle braces (not supplied) to secure 
the Stand. For each angle brace use the appropriate 
hardware to:
• Attach one side of the angle brace to the wall stud.
• Attach the other side to the Stand.
Angle brace 
(not supplied)
Stand