Wet Sounds WS 420 SQ 사용자 매뉴얼
SETTING UP A SYSTEM USING THE WS 420
4
5
1. Unplug all the RCA’s from your amps. Turn all the amp gains down.
2. Turn the radio up to find the maximum volume. Set the system with the
head unit volume at 85% of max. This is the loudest the radio should ever
go. Radios will create distortion the higher the volume is turned up. Which
will create distortion on the output signal before reaching the amps. So find
a safe easy to remember volume. If the head unit is 35. Max should be 30.
If the head unit is 40. Maximum should be 30 to 35 and so on.
3. Once you have found the maximum volume set point. Turn the radio back
down. Use a test CD that you are familiar with for tuning. Something that
has highs and lows and vocals.
4. Make sure the settings on the radio are flat. You should not tune a
system with the treble or bass up.
5. Make sure all the eq adjustments are flat. Right in the middle. Plug in all
the rcas from the eq to the amps.
6. Plug in just the RCA’s for the in boat speakers amp. Set the high pass
crossover at around 80HZ to 100HZ.
7. Turn the radio up to the max safe level found in step 2. Turn the eq up to
about ¾ of max volume.
8) Slowly turn the gain up until you hear the speakers distort. Slowly back
off the gain from that point a small amount until you hear the speakers play
as loud as they can with no distortion.
9. Unplug the RCA’s from that amp and plug the RCA’s into the amp running
the tower speakers. Set the high pass crossover on the amp for the
towerspeakers at 80HZ to 100HZ.
10. Slowly turn the gain up until you hear the speakers distort. Slowly back
off the gain from that point a small amount until you hear the speakers play
as loud as they can with no distortion.