Wet Sounds STX Micro 4 사용자 매뉴얼

5

CONNECTIONS – STX MICRO-1

7. Power (RED) Connection. It is recommended that the power connection 

be run directly to the vehicle’s battery. Run a minimum 8 Gauge wire with 
a fuse at the battery. Be sure that the outboard dual ATC fuse holder stays 
close to the amplifier. FAILURE TO USE THE SUPPLIED OUTBOARD FUSES IN 
THE INSTALLATION IS DANGEROUS AND WILL VOID THE WARRANTY!

8. Ground (BLACK) Connection. This should be connected to chassis ground 

where possible. If the vehicle does not have a chassis ground, run a wire 
directly to the negative side of the battery.

9. Remote Turn-On (BLUE) Connection. This should be connected to a wire 

that supplies +12V when powered on. The BLUE wire must receive +12V 
for the amplifier to power on. 

10. Speaker (Black and Black/White) Connections. Connect these to 

the Positive and Negative terminals of the subwoofer. Be sure the total 
impedance of the subwoofers does not fall below 2 Ohms!

11. Input. Connect this to the output of the source unit or the pass-through 

output of the STX MICRO-4. This connector is designed to accept a 3.5mm 
male plug. An RCA style adaptor such as the Wet Sounds WW-RCA-3.5mm 
2ft can be used if the source has RCA style connectors.