Brandmotion 9002-8847 사용자 매뉴얼

다운로드
페이지 9
8847 Instructions 1-29-15.docx 
Page 2 of 6 
 
Nuts on the studs. 
 
Step 5: Reinstall spare tire.
 
Install Chassis Harness 
 
Step 6: Insert connector from Camera connector 
through the rear gate vent behind tire carrier. 
 
 
Step 7: Using a plastic trim removal tool, remove 
interior panels on inside of rear gate. 
 
 
Step 8: Pull harness through the rear gate openings. 
Step 9: Use supplied Wire Ties to secure Chassis 
Harness to existing harness. 
 
Step 10: Use supplied Wire Ties to secure Chassis 
Harness to existing harness. 
 
Step 11: Use supplied Wire Ties to secure Chassis 
Harness to fabric factory wire cover. CAUTION: Leave 
enough slack to allow gate to open fully.