Yamaha YSP-5600 Digital Sound Projector 사용자 매뉴얼

a Installation

En

This unit creates surround sound by reflecting projected sound beams off the walls and 
the ceiling of your listening room. The surround sound effects produced by this unit 
may not be sufficient when this unit is installed in the following locations.

• Rooms with walls inadequate for reflecting sound beams

• Rooms with acoustically absorbent walls and ceiling

• Rooms with measurements outside the following range: 

W (3 to 7 m) × H (2 to 3.5 m) × D (3 to 7 m)

• Rooms where objects such as furniture are likely to obstruct the path of sound beams

• Rooms with less than 1.8 m from the listening position to this unit

• Rooms where the listening position is close to the walls

• Rooms where the listening position is not in front of this unit

• Rooms with a complex shape, such as a slanted ceiling (ceiling lights do not obstruct 

sound beams)

The My Surround function creates rich surround sound effects in rooms with less than 
optimal surround sound conditions. See “Channel Out” (page 72 in the Owner’s 
Manual) for more information.

• This unit’s AUTO SETUP (IntelliBeam) can be used to automatically adjust sound beams to achieve the 

optimal surround playback environment according to the listening room setup (p. 14).

Install the stands (supplied) on the bottom of the unit. Align and insert the protrusion on 
the stands into the holes on the rear panel of the unit as shown in the illustration, and 
then tighten the screws (supplied) to lock the stands in place. The stands need not be 
installed when the unit is mounted on a wall using the optional Wall Mount Bracket 
SPM-K30.

Stand (supplied)

Screws (supplied)

Stand (supplied)