MartinLogan Motion® Vision X 사용자 매뉴얼

8

 

If no stud is found: use the center most screw 
location and drill a pilot hole for the wall anchor. 
Install a wall anchor at this location. If a wall 
stud is found: drill a pilot hole into the stud.

4  Using a screw, attach the wall bracket to the 

wall. DO NOT tighten (fig. 2b).

5  Using a stud finder, determine if a wall stud 

is directly behind any of the remaining screw 
locations (fig. 2a). 

 

If no stud is found: use the top and bottom 
center-most screw locations. If a wall stud is 
found: use the top and bottom screw locations 
with a stud behind them.

 

Use a level to square the wall bracket and mark 
the remaining pilot hole locations (fig. 2b).

6  Remove the wall bracket or pivot to access the 

remaining screw locations (fig. 2b).

 

If no stud is found: drill pilot holes and install 
wall anchors. If a wall stud is found: drill pilot 
holes into the stud.

7  Using the screws, attach the wall bracket to the 

wall. DO NOT fully tighten.

8  Use a level to square the wall bracket. Tighten 

all screws (fig. 2b).

9  Attach audio and power cables as needed. 

Refer to the ‘Connection’ section of this manual.

10  Move the soundbar into place and drop the 

shoulder bolts into the wall bracket keyholes. 
Before releasing, make sure the soundbar has 
dropped fully into the keyholes and is held firm-
ly in place (fig. 3).