Netgear AC2300 Nighthawk™ 사용자 매뉴얼

The user name is admin. The default password is password. The user name and password are
case-sensitive.

The BASIC Home page displays.

Select ADVANCED > Advanced Setup > Wireless Settings.

The Wireless Settings page displays.

Scroll down below the WPS Settings section and clear the Enable MU-MIMO check box.

Click the Apply button.

Your settings are saved.

If you connected over WiFi to the network, you are disconnected from the network and must reconnect.

You can set up the router to run as an access point (AP) on the same local network as another router.

Use an Ethernet cable to connect the Internet port of this router to a LAN port in the other router.

Launch a web browser from a computer or mobile device that is connected to the network.

Enter http://www.routerlogin.net.

A login window opens.

Enter the router user name and password.

The user name is admin. The default password is password. The user name and password are
case-sensitive.

The BASIC Home page displays.

Select ADVANCED > Advanced Setup > Router/ AP / Bridge Mode.

The Router / AP / Bridge Mode page displays.

Select the AP Mode radio button.

The page adjusts.

Select an IP address setting:

Get dynamically from existing router. The other router on the network assigns an IP address to
this router while this router is in AP mode.

Use fixed IP settings on this device (not recommended). Use this setting if you want to manually
assign a specific IP address to this router while it is in AP mode. Using this option effectively requires
advanced network experience.

To avoid interference with other routers or gateways in your network, NETGEAR
recommends that you use different WiFi settings on each router. You can also turn
off the WiFi radio on the other router or gateway and use the R7000P router only for
WiFi client access.