Netgear AC2300 Nighthawk™ 사용자 매뉴얼

Select ADVANCED > Advanced Setup > VLAN/Bridge Settings.

The VLAN / Bridge Settings page displays.

Select the Enable VLAN/Bridge Group check box.

The page expands.

Select the By bridge group radio button.

The section expands.

Select a Wired Ports check box or a Wireless check box:

If your device is connected to an Ethernet port on the router, select the Wired Ports check box that
corresponds to the Ethernet port on the router to which the device is connected.

If your device is connected to your router’s WiFi network, select the Wireless check box that
corresponds to the router’s WiFi network to which the device is connected.

You must select at least one Wired Ports or Wireless check box. You can select more
than one check box.

Click the Apply button.

Your settings are saved.

Typically, you do not need to add static routes unless you use multiple routers or multiple IP subnets on
your network.

As an example of when a static route is needed, consider the following case:

Your main Internet access is through a cable modem to an ISP.

Your home network includes an ISDN router for connecting to the company where you are employed.
This router’s address on your LAN is 192.168.1.100.

Your company’s network address is 134.177.0.0.

When you set up your router, two implicit static routes were created. A default route was created with your
ISP as the gateway, and a second static route was created to your local network for all 192.168.1.x addresses.
With this configuration, if you try to access a device on the 134.177.0.0 network, your router forwards your
request to the ISP. The ISP forwards your request to the company where you are employed, and the company
firewall is likely to deny the request.

In this case you must define a static route, telling your router to access 134.177.0.0 through the ISDN router
at 192.168.1.100. Here is an example:

The Destination IP Address and IP Subnet Mask fields specify that this static route applies to all
134.177.x.x addresses.

The Gateway IP Address field specifies that all traffic for these addresses will be forwarded to the ISDN
router at 192.168.1.100.