Netgear Nighthawk™ X10 사용자 매뉴얼

The user name is admin. The default password is password. The user name and password are
case-sensitive.

The BASIC Home page displays.

Select ADVANCED > Advanced Setup > VPN Service.

The VNP page displays.

Select the Enable VPN Service radio button.

Scroll down to the Clients will use this VPN connection to access section, and select the Home Network
only radio button.

This is the default setting. The VPN connection is only to your home network, not to the Internet service
for your home network.

Click the Apply button.

Your settings are saved.

Click For Windows or For Non Windows button and download the configuration files for your VPN
clients.

Unzip the configuration files and copy them to the folder where the VPN client is installed on your device.

For a client device with Windows 64-bit system, the VPN client is installed at 

C:\Program

files\OpenVPN\config\

 by default.

Set up the router to allow VPN access to your Internet service.

See 

 on page 135.

On your computer, launch the OpenVPN application.

The OpenVPN icon displays in the Windows taskbar.

Right-click the icon and select Connect.

When the VPN connection is established, launch your Internet browser.

This feature is available only in Brazil, Russia, India, and China (the BRIC region).

When Network Address Translation (NAT) is enabled in the router, the router filters encrypted tunnel packets
through NAT, causing these packets to become invalid. VPN pass-through allows encrypted tunnel packets
to go through without being filtered and is enabled by default for IPSec, PPTP, and L2TP packets. Do not
disable VPN pass-through for IPSec, PPTP, or L2TP unless a specific reason exists.

Launch a web browser from a computer or WiFi device that is connected to the network.

Enter http://www.routerlogin.net.